Safety tips for using temporary heaters

3 minute read

On construction sites, temporary heaters are used for heating tasks like ground thawing, concrete curing, or general drying purposes. They’re handy to have — especially through the winter — but can quickly turn into hazards: improperly installed temporary heaters can lead to major fire losses on construction projects. Temporary heater safety should be a top concern among construction and contracting risks.

The most common reason for fires resulting from temporary heating? A lack of proper clearance when the unit is installed. The “salamander” or “radiant” types of temporary heaters are direct-fired devices, typically fueled by propane, diesel, or natural gas. These un-vented and self-contained heaters are the ones you’ll find most often on worksites, but since they give off such intense heat, they typically require eight feet of clearance.

Some guidelines for using temporary heaters

Proper clearance is a good first step, but it’s not the only point to consider when using a temporary heater. Here are some other things to keep in mind:

  • Only use units that are officially “listed” or “approved” by a recognized testing organization, such as UL/ULC or CSA.
  • Temporary heaters should be used for their intended purpose only, and installed and operated according to the manufacturer’s instructions.
  • Check with your insurance company to ensure the types you’re planning to use aren’t prohibited under your policy coverage.
  • Establish a written operating procedure based on the manufacturer’s instructions to ensure safe installation and operation.
  • Each heater has a data plate indicating the necessary clearances to combustibles, ventilation requirements and fuel type, etc. Adhere to those specifications!

You can also consider other types of temporary and portable heaters that may be safer to operate, like indirect-fired heaters, which are located outside the building. They require electricity to run and may not be as efficient as your salamander heaters, but they can be a good choice if you’re particularly concerned about ventilation and fire safety.

Since direct-fired heaters give off such intense heat, they typically require 8 feet of clearance. tweet

Portable heaters call for portable fire extinguishers

Where there’s smoke there’s fire, and where there’s fire there should be tools to keep it under control! Since temporary heaters carry a fire risk, you should have multi-purpose fire extinguishers with a minimum of a 3A 10BC rating close at hand if you use heaters on your construction site.

Fire extinguishers aren’t worth much if you don’t know how to use them properly. Remember the PASS acronym:

  • Pull the pin
  • Aim the nozzle at the base of the fire
  • Squeeze the trigger
  • Sweep the extinguisher from side to side

When it comes to risk, it’s not only site workers you need to worry about: you’re also responsible for the safety of visitors to your construction site. It’s important that you not only keep hazards to a minimum, but also consider that visitors may be less aware of common risks or obstacles on a construction site. Preparing for potential incidents with relevant tools and processes is always a good idea.

You should have multi-purpose fire extinguishers with a minimum of a 3A 10BC rating close at hand if you use heaters on your construction site. tweet

Alternative solutions to temporary heaters

In some cases, it can be better to avoid using temporary heaters altogether. Here are some less risky ways to get the heat you need to keep working:

  • Place a heater outside and away from the building. For hot air units, ductwork will be required to bring the heat into the building.
  • Heating units that pipe hot water into a building and distribute the heat through various methods are safer alternatives to open-flame heaters. The heater should be in a safe location outside the building.
  • If possible, rely on the building’s permanent heat source.

Using alternative solutions to temporary heating will significantly reduce your risk of fire, but when there’s no way around it, temporary heat sources can be excellent tools when used properly. Not sure if your site is as safe as it could be? Check out some other resources to help keep your people and equipment safe.